New Products

  • Armorer Tool, FDE, 2pk The chisel end of the tool can be used to pull the 1911 extractor from the slide without scratching the finish.
    Quick view

    Armorer Tool, FDE, 2pk

    $15.90
    The 10-8 Performance Armorer Tool is a simple nonmarring tool molded from glass reinforced nylon. It is useful for countless applications where use of metal tools can easily damage your work. It is...
    Add to Cart
  • Armorer Tool, Black, 2pk The chisel end of the tool can be used to pull the 1911 extractor from the slide without scratching the finish.
    Quick view

    Armorer Tool, Black, 2pk

    $15.90
    The 10-8 Performance Armorer Tool is a simple nonmarring tool molded from glass reinforced nylon. It is useful for countless applications where use of metal tools can easily damage your work. It is...
    Out of stock

View all products

Best-Selling Products

Fiber Optic Some Glock slides are thinner at the front sight hole, and the sight's mounting post may protrude. This causes the set screw to tighten against the sight instead of the slide. To correct this, file some material off the bottom of the post (indicated in silver) so that the post sits below flush.
Quick view

Glock Front Sight, Fiber Optic

$45.50 - $49.95
Precision CNC machined from hardened 4140 tool steel and finished in black QPQ salt bath nitrocarburizing (aka Melonite, same as the Glock slide). Fits: ALL Glock models, all calibers,...
Options
Slide Stop, Gen 2 Slide Stop, Gen 2
Quick view

Slide Stop, Gen 2

$55.95
*While this part is a drop in fit in many pistols, gunsmith fitting may be required on some guns.  The .200" (nominal) diameter pin is typically bigger than your factory unit (they tend to...
Options
Glock Optic Height Rear Sight Glock Optic Height Rear Sight
Quick view

Glock Optic Height Rear Sight

$48.75
Tall rear sight for clearance over slide mounted mini red dot sights (RMR, SRO, Holosun, and similar deck height. Does NOT cowitness over DeltaPoint Pro.) or suppressors.  Fits Glock dovetail,...
Options
Glock Front Sight, Extra Tall for Optic/Suppressor Glock Front Sight, Extra Tall for Optic/Suppressor
Quick view

Glock Front Sight, Extra Tall for Optic/Suppressor

$35.45 - $45.95
Extra tall front sights allow clearance over optics and suppressors. Blade is .125" wide with 40lpi serrations to provide crisp visual focus and glare reduction.  Finished in black QPQ salt bath...
Options
Armorer Block, 1911/2011 Armorer Block, 1911/2011
Quick view

Armorer Block, 1911/2011

$67.95
The Armorer Block is the culmination of years of tinkering on the 1911 and getting by with a box of tools and fixtures that didn't quite do what I wanted.   This 4"x4"x1.25" block is CNC...
Out of stock
Glock Magazine Base Pad, Set of 4 Glock Magazine Base Pad, Set of 4
Quick view

Glock Magazine Base Pad, Set of 4

$19.80
These base pads are injection molded from glass reinforced nylon, and they are super tough and resistant to impact.  Our pads fit and install the same as the factory floor plates, use the...
Options

View all products

Advice & Articles

CONNECT WITH US: